Hyundai Tucson: Maintenance
- Engine compartment
- Owner maintenance
- Scheduled maintenance services
- Explanation of scheduled maintenance items
- Engine oil
- Engine coolant
- Brake fluid
- Washer fluid
- Parking brake
- Air cleaner
- Climate control air cleaner
- Wiper blades
- Battery
- Tires and wheels
- Tire care
- Recommended cold tire inflation pressures
- Check tire inflation pressure
- Tire rotation
- Wheel alignment and tire balance
- Tire replacement
- Wheel replacement
- Tire traction
- Tire maintenance
- Tire sidewall labeling
- Tire terminology and definitions
- All season tires
- Summer tires
- Snow tires
- Radial-ply tires
- Low aspect ratio tires
- Fuses
- Instrument panel fuse replacement
- Memory fuse (SHUNT connector)
- Engine compartment panel fuse replacement
- Fuse/Relay panel description
- Light bulbs
- Headlight, parking light, turn signal light, side marker and front fog light bulb replacement
- Side repeater light replacement
- Rear combination light bulb replacement
- High mounted stop light
- License plate light bulb replacement
- Interior light bulb replacement
- Appearance care
- Emission control system
- 1. Crankcase emission control system
- 2. Evaporative emission control system including Onboard Refueling Vapor Recovery (ORVR)
- 3. Exhaust emission control system
- California perchlorate notice
Tie-down hook
WARNING
Do not use the tie-down hook(s) for towing purposes. If the tiedown hook(s)
are used for towing, the tie-down hook(s) or bumper will be damaged and this could
lead to serious injury. ...
Other information:
Hyundai Tucson (LM) 2010-2015 Service Manual: Description and Operation
Description
The immobilizer system will disable the vehicle unless the
proper ignition key is used, in addition to the currently available
anti-theft systems such as car alarms, the immobilizer system aims to
drastically reduce the rate of auto theft.
1.
Encrypted SMARTRA type immobilizer ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Starter Relay Repair procedures
Inspection
1.
Disconnect the battery negative terminal.
2.
Remove the fuse box cover.
3.
Remove the starter relay (A).
4.
Using an ohmmeter, check that there is continuity between each terminal.
TerminalValueMeasure30 - 871Mx or HigherIf there is continuity, replace the relay.
...