Hyundai Tucson: Light bulbs / High mounted stop light
1. Open the tailgate.
2. Gently remove the center cover of the rear tailgate trim.
3. Disconnect the electrical connector.
4. Loosen the retaining nuts and remove the spoiler.
5. Remove the high mounted stop light assembly (A) after loosening the nuts and washer nozzle (B).
6. Reinstall a new light assembly in the reverse order of removal.
Inside light
Tail light and Back-up light
1. Open the tailgate.
2. Remove the service cover using a flat-blade screwdriver.
3. Remove the socket from the assembly by turning the socket counterclockwise
un ...
License plate light bulb replacement
1. Loosen the lens retaining screws with a philips head screwdriver.
2. Remove the lens.
3. Remove the bulb by pulling it straight out.
4. Install a new bulb.
5. Reinstall the lens securely wi ...
Other information:
Hyundai Tucson (LM) 2010-2015 Service Manual: TJ Joint Components and Components Location
Components
[LH]
1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Shaft6. TJ boot band7. TJ boot8. Spider assembly9. Retainer ring10. TJ housing11. Housing circlip
[RH]
1. BJ assembly2. BJ circlip3. BJ boot band4. BJ boot5. Dynamic damper band6. Dynamic damper7. Shaft8. TJ b ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Master Cylinder Repair procedures
Removal
1.
Turm ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the battery positive terminal and them remove the battery.
3.
Disconnect the ECM connector and the ECM and battery tray.
4.
Disconnect the brake fluid level switch connector (A), and remo ...
