Hyundai Tucson: Headlight, parking light, turn signal light, side marker and front fog light bulb replacement / Fog light bulbs
1. Remove the front bumper under cover.
2. Reach your hand into the back of the front bumper.
3. Disconnect the power connector from the socket.
4. Remove the bulb-socket from the housing by turning the socket counter clockwise until the tabs on the socket align with the slots on the housing.
5. Install the new bulb-socket into the housing by aligning the tabs on the socket with the slots in the housing. Push the socket into the housing and turn the socket clockwise.
6. Connect the power connector to the socket.
7. Reinstall the front bumper under cover.
Parking (Position) light bulbs
If the LED light does not operate, have the vehicle checked by an authorized
HYUNDAI dealer. ...
Side repeater light replacement
â– Type A
If the LED light does not operate, have the vehicle checked by an authorized
HYUNDAI dealer.
â– Type B
1. Remove the light assembly from the vehicle by prying the lens and pul ...
Other information:
Hyundai Tucson (LM) 2010-2015 Service Manual: Auto Light Sensor Repair procedures
Inspection
In the state of IGN1 ON, when multi function switch module
detects auto light switch on, tail lamp relay output and head lamp low
relay output are controlled according to auto light sensor's input.
The auto light control doesn't work if the pin sunlight
supply (5V regulated powe ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Fuel Pressure Control Valve Repair procedures
Inspection
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the fuel pressure regulator valve connector.
3.
Measure resistance between the fuel pressure regulator valve terminals 1 and 2.
4.
Check that the resistance is within the specifica ...
