Checking the brake fluid level
Check the fluid level in the reservoir periodically. The fluid level should be between MAX and MIN marks on the side of the reservoir.
Before removing the reservoir cap and adding brake fluid, clean the area around the reservoir cap thoroughly to prevent brake fluid contamination.
If the level is low, add the specified brake fluid to the MAX level. The level will fall with accumulated mileage.
This is a normal condition associated with the wear of the brake linings. If the fluid level is excessively low, have the brake system checked by an authorized HYUNDAI dealer.
WARNING
If the brake system requires frequent additions of fluid this could indicate a leak in the brake system. Have the vehicle inspected by an authorized HYUNDAI dealer.
WARNING
Do not allow brake fluid to come in contact with your eyes. If brake fluid comes in contact with your eyes, flush your eyes with clean water for at least 15 minutes and get immediate medical attention.
CAUTION
✽ NOTICE
Use only the specified brake fluid
Hyundai Tucson (LM) 2010-2015 Service Manual: Receiver-Drier Repair procedures
Replacement
1.
Remove the condenser, and then remove the bottom cap (B) with L wrench (A) from the condenser.
Tightening torque :
20 ~ 25 N.m (2.0 ~ 2.5 kgf.m, 14.5 ~ 18.2 lb-ft)
2.
Remove the desiccant (A) from condenser using a long nose plier. Check for crumbled desiccant and cl ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Front Door Components and Components Location
Components
1.Door inside handle housing2. Door trim3. Door belt inner weatherstrip 4. Door screen 5. Door module 6. Quadrant inner cover 7. Door panel 8. Door belt outside weatherstrip9. Door side weatherstrip10. Body side weatherstrip11. Door hinge
...