Hyundai Tucson: Normal maintenance schedule / 135,000 miles (216,000 km) or 108 months
- Rotating tires
- Inspect air cleaner filter
- Inspect vacuum hose
- Inspect air conditioning refrigerant
- Inspect brake hoses and lines
- Inspect drive shafts and boots
- Inspect exhaust pipe and muffler
- Inspect front brake disc/pads, calipers
- Inspect propeller shaft (AWD)
- Inspect rear brake disc/pads
- Inspect steering gear box, linkage & boots/lower arm ball joint, upper arm ball joint
- Inspect suspension mounting bolts
- Inspect drive belts (First, 60,000 miles (96,000 km) or 72 months after every 15,000 miles (24,000 km) or 24 months) *5
- Replace climate control air filter (for evaporator and blower unit)
- Replace engine oil and filter (135,000 miles (216,000 km) or 216 months)
- Add fuel additive *1 (135,000 miles (216,000 km) or 216 months)
127,500 miles (204,000 km) or 102 month
Rotating tires
Inspect air cleaner filter
Inspect vacuum hose
Replace engine oil and filter (127,500 miles (204,000 km) or 204 months)
Add fuel additive *1 (127,500 miles (204,000 km) or 20 ...
142,500 miles (228,000 km) or 114 months
Rotating tires
Inspect air cleaner filter
Inspect vacuum hose
Replace engine oil and filter (142,500 miles (228,000 km) or 228 months)
Add fuel additive *1 (142,500 miles (228,000 km) or 22 ...
Other information:
Hyundai Tucson (LM) 2010-2015 Service Manual: Overhead Console Lamp Repair procedures
Inspection
Remove the overhead console lamp assembly then check for
continuity between terminals. If the continuity is not as specified,
replace the map lamp switch.Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the overhead console lamp assembly.
(Refer to the B ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Seat Belt Pretensioner (BPT) Repair procedures
Removal
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
To remove the seat belt anchor pretensioner (C), keep on
pushing the lock pins (A) as arrow direction. And then remove the seat
belt after pushing the lock pin (B).
3.
Rem ...
