Hyundai Tucson: Immobilizer System / Troubleshooting

Diagnosis Of Immobilizer Faults
-
Communication between the ECM and the SMARTRA.
-
Function of the SMARTRA and the transponder.
-
Data (stored in the ECM related to the immobilizer function.
The following table shows the assignment of immobilizer related faults to each type:
Immobilizer Related Faults
Fault types
Diagnostic codes
PCM(ECM) fault
1.
Non-Immobilizer-EMS connected to an Immobilizer
P1610
Transponder key fault
1.
Transponder not in password mode
2.
Transponder transport data has been changed.
P1674
(Transponder status error)
Transponder key fault
1.
Transponder programming error
P1675
(Transponder programming error)
SMARTRA fault
1.
Invalid message from SMARTRA to PCM(ECM)
P1676
(SMARTRA message error)
SMARTRA fault
1.
Virgin SMARTRA at learnt EMS
2.
Neutral SMARTRA at learnt EMS
3.
Incorrect the Authentication of EMS and SMARTRA
4.
Locking of SMARTRA
P169A
(SMARTRA Authentication fail)
SMARTRA fault
1.
No response from SMARTRA
2.
Antenna coil error
3.
Communication line error (Open/Short etc.)
4.
Invalid message from SMARTRA to PCM(ECM)
P1690
(SMARTRA no response)
Antenna coil fault
1.
Antenna coil open/short circuit
P1691
(Antenna coil error)
Immobilizer indicator lamp fault
1.
Immobilizer indicator lamp error (Cluster)
P1692
(Immobilizer lamp error)
Transponder key fault
1.
Corrupted data from transponder
2.
More than one transponder in the magnetic field (Antenna coil)
3.
No transponder (Key without transponder) in the magnetic field (Antenna coil)
P1693
(Transponder no response error/invalid response)
PCM(ECM) fault
1.
Request from PCM(ECM) is invalid
(Protocol layer violation- Invalid request, check sum error etc.)
P1694
(PCM(ECM) message error)
PCM(ECM) internal permanent memory (EEPROM) fault
1.
PCM(ECM) internal permanent memory (EEPROM) fault
2.
Invalid write operation to permanent memory (EEPROM)
P1695
(PCM(ECM) memory error)
Invalid key fault
1.
Virgin transponder at PCM(ECM) status "Learnt"
Learnt (Invalid) Transponder at PCM(ECM) status "Learnt"(Authentication fail)
P1696
(Authentication fail)
Hi-Scan fault
1.
Hi-Scan message error
P1697
Locked by timer
1.
Exceeding the maximum limit of Twice IGN ON (x 32 times)
P1699
(Twice IG ON over trial)

Antenna Coil Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the steering column upper and lower shrouds (A). [LHD] [RHD]     Take care not to damage and scratch the ...

Rear Parking Assist System
...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Crankshaft Position Sensor (CKPS) Description and Operation
Description Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the engine control system. If there is no CKPS signal input, the engine may stop because of CKPS signal missing. This sensor is installed in ladder frame and generates ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Panoramaroof Motor Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the roof trim. (Refer to the BD group - "Roof trim") 3. Remove the panoramaroof motor (A) after disconnecting the connector (10 Pin). 4. Ground the terminals as below table, and check that the panoramaroof unit o ...

© 2010-2024 www.htmanual.net