Hyundai Tucson: Back View Camera System / Description and Operation

Hyundai Tucson (LM) 2010-2015 Service Manual / Body Electrical System / Back View Camera System / Description and Operation

Description

Back view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position.

This system is a supplemental system that shows behind the vehicle through the ECM (Reverse Display Room Mirror) mirror or AVN head unit while backing-up.

This system is a supplementary function only. It is the responsibility of the driver or always check the inside/ outside rearview mirror and the area behind the vehicle before and while backing up because there is a dead zone that can't see through the camera.

Schematic Diagrams

Circuit Diagram ...

Repair procedures

Removal 1. Remove the liftgate trim in the trunk after removing the screws and clips. (Refer to the BD group - "Liftgate") 2. Remove the liftgate garnish (A) after disconnecting the connector ...

Other information:

Hyundai Tucson (LM) 2010-2015 Owners Manual: Key ignition switch
WARNING NEVER turn the ignition switch to the LOCK or ACC position while the vehicle is in motion except in an emergency. This will result in the engine turning off and loss of power assist for the steering and brake systems. This may lead to loss of directional control and braking functi ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Description and Operation
Description The starting system includes the battery, starter, solenoid switch, ignition switch, inhibitor switch (A/T), clutch pedal switch (M/T), ignition lock switch, connection wires and the battery cable. When the ignition key is turned to the start position, current flows and energizes ...