Hyundai Tucson: Engine Control System / Components and Components Location
| Components Location |
| 1. Engine Control Module (ECM) 2. Manifold Absolute Pressure Sensor (MAPS) 3. Intake Air Temperature Sensor (IATS) 4. Engine Coolant Temperature Sensor (ECTS) 5. Throttle Position Sensor (TPS) [integrated into ETC Module] 6. Crankshaft Position Sensor (CKPS) 7. Camshaft Position Sensor (CMPS) [Bank 1 / Intake] 8. Camshaft Position Sensor (CMPS) [Bank 1 / Exhaust] 9. Knock Sensor (KS) 10. Heated Oxygen Sensor (HO2S) [Bank 1 / Sensor 1] 11. Heated Oxygen Sensor (HO2S) [Bank 1 / Sensor 2] 12. Rail Pressure Sensor (RPS) 13. Accelerator Position Sensor (APS) 14. Fuel Tank Pressure Sensor (FTPS) 15. Fuel Level Sender (FLS) | 16. A/C Pressure Transducer (APT) 17. ETC Motor [integrated into ETC Module] 18. Injector 19. Purge Control Solenoid Valve (PCSV) 20. CVVT Oil Control Valve (OCV) [Bank 1 / Intake] 21. CVVT Oil Control Valve (OCV) [Bank 1 / Exhaust] 22. Variable Intake Solenoid (VIS) Valve 23. Fuel Pressure Control Valve (FPCV) 24. Canister Close Valve (CCV) 25. Ignition Coil 26. Main Relay [EMS Box] 27. Fuel Pump Relay [EMS Box] 28. Data Link Connector (DLC) [16-Pin] 29. Multi-Purpose Check Connector [20-Pin] |
| 1. Engine Control Module (ECM) | 2. Manifold Absolute Pressure Sensor (MAPS) 3. Intake Air Temperature Sensor (IATS) 22. Variable Intake Solenoid (VIS) Valve |
|
|
| 4. Engine Coolant Temperature Sensor (ECTS) | 5. Throttle Position Sensor (TPS) [integrated into ETC Module] 17. ETC Motor [integrated into ETC Module] |
|
|
| 6. Crankshaft Position Sensor (CKPS) | 7. Camshaft Position Sensor (CMPS) [Bank 1 / Intake] |
|
|
| 8. Camshaft Position Sensor (CMPS) [Bank 1 / Exhaust] | 9. Knock Sensor (KS) |
|
|
| 10. Heated Oxygen Sensor (HO2S) [Bank 1/Sensor 1] | 11. Heated Oxygen Sensor (HO2S) [Bank 1/Sensor 2] |
|
|
| 12. Rail Pressure Sensor (RPS) 18. Injector | 13. Accelerator Position Sensor (APS) |
|
|
| 14. Fuel Tank Pressure Sensor (FTPS) | 15. Fuel Level Sender (FLS) |
|
|
| 16. A/C Pressure Transducer (APT) | 19. Purge Control Solenoid Valve (PCSV) |
|
|
| 20. CVVT Oil Control Valve (OCV) [Bank 1 / Intake] | 21. CVVT Oil Control Valve (OCV) [Bank 1 / Exhaust] |
|
|
| 23. Fuel Pressure Control Valve (FPCV) | 24. Canister Close Valve (CCV) |
|
|
| 25. Ignition Coil | 26. Main Relay [EMS Box] 27. Fuel Pump Relay [EMS Box] 29. Multi-Purpose Check Connector [20-Pin] |
|
|
| 28. Data Link Connector (DLC) [16-Pin] | |
|
Description and Operation
OBD-II review
1. Overview
The California Air Resources Board (CARB) began regulation of
On Board Diagnostics (OBD) for vehicles sold in California beginning
with the 1988 model year. The first ...
Engine Control Module (ECM) Schematic Diagrams
ECM Terminal And Input/Output signal [M/T]
ECM Terminal Function (M/T)
Connector [C200-MA]
Pin No.DescriptionConnected to1Injector (Cylinder #3) [High] control outputInjector (Cylinder #3)2In ...
Other information:
Hyundai Tucson (LM) 2010-2015 Service Manual: ICM (Integrated Circuit Module) Relay Box Repair procedures
Inspection
Rear Wiper Relay
Check for continuity between the terminals.
1.
There should be continuity between the No.11 in the A and
No.12 in the A terminals when power and ground are connected to the No.2
in the A and No.11 in the A terminals.
2.
There should be no continuity between ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Anchor Pretensioner Description and Operation
Description
Anchor pretensioner operates as well as belt Pretensioner at
the same time If it gets into its deploy condition after a collision. It
is located at near anchor on front seat and it is an equipment to make
up for the existing short stroke. Anchor pretensioner is supported by
tw ...
