Hyundai Tucson: General Information / Repair procedures

Service Adjustment Procedure
Steering Wheel Play Inspection
1.
Turn the steering wheel so that the front wheels can face straight ahead.
2.
Measure the distance that the steering wheel can be turned with out moving the front wheels.

Standard value : 0 ~ 30mm (1.18in.) or less

3.
If the play exceeds standard value, inspect the steering column, shaft, and linkages.
Checking Stationary Steering Effort
1.
Position the vehicle on a level surface and place the steering wheel in the straight ahead position.
2.
Start the engine and turn the steering wheel from lock to lock several times to warm up the power steering fluid.
3.
Attach a spring scale to the steering wheel. With the engine speed 500~700RPM, pull the scale and read it as soon as the tires begin to turn.

Standard value : 3.0kgf

4.
If the measured value exceeds standard value, inspect the power steering gear box and pump.
Troubleshooting
Troubleshooting SymptomProbable causeRemedyplay in steeringLoose yoke plugRetightenLoose steering gear mounting boltsRetightenLoose or worn tie rod endRetighten or replace as necessarySteering w ...

Steering wheel
...

Other information:

Hyundai Tucson (LM) 2010-2015 Owners Manual: AWD LOCK indicator (if equipped)
The AWD LOCK indicator light is illuminated when the AWD LOCK button is pushed. The purpose of this AWD LOCK mode is to increase the drive power when driving on wet pavement, snow-covered roads and/or off-road.The AWD LOCK indicator light is turned off by pushing the button again. CAUTION ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Injector Troubleshooting
Signal Waveform The three waveforms below are taken from the #1 and #4 injectors. The top waveform is from the high side (feed side) of the #1 and #4 injectors, while the middle waveform is from the low side (ground side) of the #1 injector and the bottom waveform is from the low side of ...

© 2010-2024 www.htmanual.net