Hyundai Tucson: Manual Transaxle System / Manual Transaxle Control System
- Shift Lever Components and Components Location
- Shift Lever Repair procedures
- Control Cable Components and Components Location
- Control Cable Repair procedures
- Control Shaft Assembly Description and Operation
- Control Shaft Assembly Repair procedures
Back-up Lamp Switch Repair procedures
Inspection
1.
Disconnect the back up lamp switch connector (A).
2.
Check the continuity between no. 1 and 2 terminals of backup
lamp switch. When the shift lever is in reverse, there should ...
Shift Lever Components and Components Location
Components
1. Shift lever knob2. Shift lever assembly3. Select cable assembly4. Shift cable assembly
...
Other information:
Hyundai Tucson (LM) 2010-2015 Service Manual: Muffler Repair procedures
Removal and Installation
Front Muffler
1.
Disconnect the front oxygen sensor connector (A) and then remove it from the bracket.
2.
Remove the front muffler (B).
Tightening torque :
39.2 ~ 58.8 N.m (4.0 ~ 6.0 kgf.m, 28.9 ~ 43.4 lb-ft)
When installing, replace wit ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the resistance is within the specification.
Removal
Replacing an on/off soleno ...
