Hyundai Tucson: Starting System / Description and Operation

Hyundai Tucson (LM) 2010-2015 Service Manual / Engine Electrical System / Starting System / Description and Operation

Description

The starting system includes the battery, starter, solenoid switch, ignition switch, inhibitor switch (A/T), clutch pedal switch (M/T), ignition lock switch, connection wires and the battery cable.

When the ignition key is turned to the start position, current flows and energizes the starter motor's solenoid coil.

The solenoid plunger and clutch shift lever are activated, and the clutch pinion engages the ring gear.

The contacts close and the starter motor cranks.

In order to prevent damage caused by excessive rotation of the starter armature when the engine starts, the clutch pinion gear overruns.

Troubleshooting

Troubleshooting • The battery must be in good condition and fully charged for this troubleshooting. ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Luggage Room Lamp Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the luggage room lamp (B) when prying the hole (A) with a flat-up screwdriver 3. Remove the luggage room lamp bulb in case of necessity Installation 1. Replace the lamp bulb. 2. Install the luggage room lamp asse ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Fuel Tank Pressure Sensor (FTPS) Repair procedures
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the FTPS. Specification: Refer to "Specification" Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the rear seat. (Refer to Body ...